Printed on Stereo Lithography machine.
Goals were to encourage more airflow with curves, have the Air Unit to be retained with a snap in fit, have more room for the cables wedged between the camera and unit, and have the camera much closer to the front so that it could be tilted down and still not see the nose cone.
This is adjustable between 0 (horizontal) and 45 degrees down and assumed double-sided tape or Velcro® is holding it in (so that is figured into the height).
You may need to extend the wires of the DJI air unit. You can do this with either an extension cable, or just extend the existing wires.
Only the mount is included. No aircraft or electronics. Inspired by excellent design concept by harkal.
Some of these are shown in gray for my craft, but the actual product will be black.