2D Patterns (slice Puzzles) made out of 3D Models

PaulNoiseLess
Posts: 5
Joined: Mon Apr 22, 2013 3:39 pm

2D Patterns (slice Puzzles) made out of 3D Models

Postby PaulNoiseLess » Wed May 22, 2013 8:58 pm

I just wanted to share with you some info: I was looking for a Soft for building 2D Puzzles (patterns) out of my 3D Models, sliced ones. I found AutoDesk 123D Make (free) to be the best by now. Quite tricky but those usual with 3D CAD’s can get it on the run in just few minutes. STL and DXF friendly. I made this model out of a MonoCore Suppressor (45 parts). Not ready for printing yet but not far. Little Vid follows:

http://youtu.be/_4lNsGQmRzM

Return to “Software Programs - Slicers, Printer Controllers, Firmware, and 3D Modeling”

Who is online

Users browsing this forum: Google [Bot] and 1 guest