Lulzbot TAZ - my build log thread.

User avatar
rsilvers
Site Admin
Posts: 266
Joined: Sun Apr 21, 2013 2:20 pm

Re: Lulzbot TAZ - my build log thread.

Postby rsilvers » Thu Aug 29, 2013 9:53 am

You can get 10 floor tiles for $60:

http://www.homedepot.com/p/M-S-Internat ... h9gKWRATs8

Then sell the rest as "Polished 3D printer built plates" for $50 each.

I would get this:

http://www.homedepot.com/p/Erias-Home-D ... h9ftmRATs8

cabbage_breath
Posts: 8
Joined: Tue Aug 06, 2013 8:06 am

Re: Lulzbot TAZ - my build log thread.

Postby cabbage_breath » Fri Aug 30, 2013 9:05 am

Hmmm... great idea....

I found the awesomest heated bed idea: http://www.thingiverse.com/thing:12727

I'm running out of money so forget the $60 silicone heater from QU-BD.

Heated bed cost just went from $95 to $20 !

It will be an interesting to see what kind of power it uses. The RAMBO is rated for 15 amperes at 12 volts. So I may have to run this right from the power supply or I will have to modifty the RAMBO board. page rambo_development on the reprap wiki mentions something about a working around a fuse.

I've got everything sourced except for the hot end and the electronics. I'm trying to get a better price on the budaschnozzle 2.0 by asking for quotes from machine shops but everything i get back is practically double the price of the fully assembled part. And the budaschnozzle 2.0 is back ordered until september...


Return to “Assembly / Building / Troubleshooting Matter Replication Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests